Lainaus:

---

Here was the official reply from ABIT support:

Dear Customer,

POST code 2A is memory related issue.

Please test the memory one by one in each slot to make sure they are working properly.

You can also try different known good memory to compare the result.

Please clear the CMOS using the jumper before you start up the system. For CMOS clear instructions, please refer to the user's manual.
http://www.abit-usa.com/faq/mb/2002073001.php

Discharge CMOS :
- shut down the system
- unplug the power cord from the back of the power supply
- switch the CMOS jumper to discharge position (please refer to your user manual)
- wait 1minute
- put the jumper back to normal position
- Press DEL to enter CMOS setting, load fail safe default.
- Then Load optimized default
- Newer Model does not need this steps. SOFT MENU, and set the CPU operating speed accordingly (some models has guru uility)
- make sure you save the setting then exit the BIOS.

Best Regards,

Abit FAE Team
www.abit-usa.com

---